i just got this zooma 33cc scooter from a guy of cl. It ran amazing until i had to put more gas in it. He told me that it is a 33cc. Anyways i put more gas along with some yamalube 2 stroke oil in with the gas because it has a weedwacker engine. (he also said so) Now it wont start what so ever. when you hold the gas and pull on it the only thing that happens it that gas spits out the exhaust pipe. If it doesnt just smoking then it doesnt start. Was puting yamalube in it a bad idea? what caused this? How do i fix this??!! Thank you in advance! :)
Copyright © 2024 Q2A.MX - All rights reserved.
Answers & Comments
How much 2 stroke oil did you put in the mixture? To strong of a mixture and it will keep fouling the spark plug. You'll need to remove and clean the plug if so, but it might keep happening until the mixture is sorted out (You can add a little more fuel each time if so, to even it out).
Did you run the fuel tank empty? IF so, this could allow bits of debris that sit on the bottom of the fuel tank into the carburettor and plug up the jets or passages. Which could mean that the carburettor will need a clean out because jets are blocked (Pilot jet controls starting). If so, all you need to do is remove float bowl, remove jets and blow them out with air. Also blow air down the passages jets where removed from. Use a straw or similar. Would also be good to remove float and float valve needle (Connected to float) and also blow down the passage that the valve needle sits in.
its flooded, yank the plug out and clean and dry it, leave it out over night, then install the spark plug and try to start it