I was going to install a aftermarket stereo and was just going to hardwire it so I cut the wires to the stock stereo, only to find out that I couldn't find anywhere online, the wire color code...I reconnected the stock wire harness but now the stereo won't work, all the buttons light up, but the display box doesn't and I can't get any music out of it. Anybody able to give me advice on what I did wrong? If your just going to criticise me on cutting the harness, don't bother. The @$$hole at radioshack already did that.
Copyright © 2024 Q2A.MX - All rights reserved.
Answers & Comments
Verified answer
Constant 12V+ Blue/Yellow
Switched 12V+ Gray
Ground Brown
Illumination Green
Dimmer White/Green
Antenna Driver's Pillar
Front Speakers 6 1/2" Doors
Left Front (+) n/a
Left Front (-) n/a
Right Front (+) n/a
Right Front (-) n/a
Rear Speakers 6 1/2" Rear Deck
Left Rear (+) n/a
Left Rear (-) n/a
Right Rear (+) n/a
Right Rear (-) n/a
Is the wiring colors, but you need to check every fuse, and probably replace a relay or more...
it happens, so it's ok, been there when I started installing a few hundred years ago ;)
Good Luck!!!
I hope that helped